MIMAKI ML Tiger-1800B MKII, Руководство по эксплуатации

Страница: 126 / 174

Chapter 7 Operation, Adjustment, and Maintenance
7-6
Adjust the Squeegee Blade
It is necessary to reconfirm the height of the squeegee blade. Especially check if noise increases or water drops are seen
on the belt.
If the noise increases significantly after readjustment, first lower the height until the belt starts to get wet.
Next, increase the height again until the belt dries. We recommend you to check the entire belt.
Do not apply excessive pressure to the belt by squeegee blade and brush. Because the squeegee blade has a lot of noise,
the belt adhesive layer wears out, and there is a possibility that the brush scatters water.
For the adjustment operation, refer the following procedure.
• The installed squeegee blades could be different according to final configuration of the machine.
Procedure Adjust the squeegee blade
S Mode Key Indication Operation Reference
1
Adjust the squeegee blade in the following cases.
When water droplets are attached to the belt
When noise and vibration increase
2
Use the relevant control function to lower the rear part
of the tank.
3
Unlock the washing tank and remove it from the
machine.
4
Loosen the specified screw and adjust the position of
the squeegee blade, then tighten the screw when it
reaches the correct position.
Adjust the squeegee blade
End of procedure
Adjustment screws