MIMAKI ML Tiger-1800B MKII, Руководство по эксплуатации

Страница: 152 / 174

Chapter 9 MAINTENANCE
9-8
F469 1 or 2
UNITECH
HEATER Generic
Alarm
Alarm generated in
UNITECH HEATER
1. Remove the cause of alarm of UNITECH HEATER.
2. Tap the [DETAIL] button in [SYSTEM ALARM], and
tap the [CLEAR ALARM] button.
3. If the alarm appears again even after tapping the
[Alarm Clear] button, turn off the power of the built-in
PC and then the printer. After a while, turn on the
power of the printer and then the PC.
4. If the Alarm appears again, contact your local
distributor, our sales office, or service center.
F471 3
Printing position
settings Alarm Carriage print position
setting error 1. Tap the [DETAIL] button in [SYSTEM ALARM], and
tap the [CLEAR ALARM] button.
2. If the alarm appears again even after tapping the
[Alarm Clear] button, turn off the power of the built-in
PC and then the printer. After a while, turn on the
power of the printer and then the PC.
3. If the Alarm appears again, contact your local
distributor, our sales office, or service center.
F472 3
Carriage printing
height setting
Alarm
Carriage print height
setting error
F473
0 or 2
or 3
Folds Alarm
The media floated
The carriage jam
sensor has responded.
1. Set again so that the media does not float off the belt.
2. Tap the [DETAIL] button in [SYSTEM ALARM], and
tap the [CLEAR ALARM] button.
If the media continues to float :
3. Adjust the pressure of the pressure roller.
4. Turn on the belt heater.
5. Replace the adhesive.
6. If the above measures do not resolve the error, tap
the [DETAIL] button from [SYSTEM ALARM], and
then tap the [CLEAR ALARM] button.
7. If the alarm appears again even after tapping the
[Alarm Clear] button, turn off the power of the built-in
PC and then the printer. After a while, turn on the
power of the printer and then the PC.
8. If the Alarm appears again, contact your local
distributor, our sales office, or service center.
F474 3
Carriage lateral
folds safety device
Alarm
Carriage crashed into
the media.
1. Remove the contact media and set it again.
2. Tap the [DETAIL] button in [SYSTEM ALARM], and
tap the [CLEAR ALARM] button.
3. If the alarm appears again even after tapping the
[Alarm Clear] button, turn off the power of the built-in
PC and then the printer. After a while, turn on the
power of the printer and then the PC.
4. If the Alarm appears again, contact your local
distributor, our sales office, or service center.
F475 3
Purge quote too
low (3[mm]) Purge position setting
error 1. Tap the [DETAIL] button in [SYSTEM ALARM], and
tap the [CLEAR ALARM] button.
2. If the alarm appears again even after tapping the
[Alarm Clear] button, turn off the power of the built-in
PC and then the printer. After a while, turn on the
power of the printer and then the PC.
3. If the Alarm appears again, contact your local
distributor, our sales office, or service center.
F476 3
Cycle doesn't
START -
Maintenance
Enable reason
Under maintenance
F487 3
Carriage
movement Safety
PX Alarm PLC parameter error or
Carriage up / down
operation error
F488 2 Belt Heather Alarm Belt heater error
Error
No.
Error
level
Error displayed Cause Measures