MIMAKI ML Tiger-1800B MKII, Руководство по эксплуатации

Страница: 128 / 174

Chapter 7 Operation, Adjustment, and Maintenance
7-8
Applying adhesive to the belt
For use in the textile printing model, we recommend that you prepare an adhesive at a 4:1 ratio of resin bonded type
Atrafix ML/K ATR 1947 and neutral base Unilevel ML ATR 1948.
* The composition of the adhesive material depends on the media used.
Increase or decrease the percentage of resin to increase or decrease the fixing force of the media to the belt.
After mixing ingredients and preparing the amount of adhesive necessary for coating, follow the procedure below.
• Turn the exclusion key before doing this.
• Do not activate the heater during this operation. Also, turn off the cleaning system.
Procedure Applying adhesive to the belt
S Mode Key Indication Operation Reference
1
We recommend that you attach two strips of adhesive
tape (width 25 mm) to the end of the belt so that the
adhesive does not leak out.
Figure
below
2 Set the belt jog reverse direction mode.
3
Place the doctor to apply the agent to the support and
evenly apply the first adhesive layer to the belt.
4
We recommend that you attach an initial point (mark)
to the adhesive tape so that you can see that the belt
goes one rotation.
Figure
below
5
Adhesive composition:
80% Atrafix ML/K ATR1947 Resin
20% Unilevel ML ATR1948 Neutral Base
7-8