MIMAKI ML Tiger-1800B MKII, Руководство по эксплуатации

Страница: 153 / 174

Chapter 9 MAINTENANCE
9-9
1
2
9
4
5
6
F489 1 or 2 MEDIA END Alarm
The media end was
detected in the
UNWINDER unit.
1. Check if there is a hole in the media coming out of the
UNWINDER unit. If there is a hole, feed the media
until it comes out of the print area, then tap the
[DETAIL] button in [SYSTEM ALARM], and tap the
[CLEAR ALARM] button.
2. If the alarm appears again even after tapping the
[Alarm Clear] button, turn off the power of the built-in
PC and then the printer. After a while, turn on the
power of the printer and then the PC.
3. If the Alarm appears again, contact your local
distributor, our sales office, or service center.
F512 2
Unwinder Dancer
Roll Up Alarm
Dancing bar of the
feeding unit has
reached its upper limit.
[For Unwinder Paper]
1. Level the dancing bar in the local mode. (Manual feed
etc.)
2. Check that the operation mode of the UNWINDER
unit is set to Auto.
3. Tap the [DETAIL] button in [SYSTEM ALARM], and
tap the [CLEAR ALARM] button.
4. If the alarm appears again even after tapping the
[Alarm Clear] button, turn off the power of the built-in
PC and then the printer. After a while, turn on the
power of the printer and then the PC.
5. If the Alarm appears again, contact your local
distributor, our sales office, or service center.
[For Unwinder Fabric]
1. In the local mode, move the dancing bar to the
approx. center of the movement range.(Manual feed
etc.)
2. Check that the operation mode of the UNWINDER
unit is set to Auto.
3. Tap the [DETAIL] button in [SYSTEM ALARM], and
tap the [CLEAR ALARM] button.
4. If the alarm appears again even after tapping the
[Alarm Clear] button, turn off the power of the built-in
PC and then the printer. After a while, turn on the
power of the printer and then the PC.
5. If the Alarm appears again, contact your local
distributor, our sales office, or service center.
Error
No.
Error
level
Error displayed Cause Measures