Magnetek Impulse G+ series 4, Техническое руководство

Страница: 97 / 248

IMPULSE•G+/VG+ Series 4 Technical Manual
November 2022
Page 97
Table 5-31: Anti-Shock Parameter Settings
Parameter Display Function Range Default
C07-12 Anti-Shock Enables or disables the Anti-Shock function. 0–2 0
0 Disabled Anti-Shock is disabled.
1 Enabled Anti-Shock is enabled always.
2 Enbl, Not In MSpd Disables Anti-Shock if Micro-Speed is
enabled.
C07-13 Enabling Freq Anti-Shock is disabled until the output
frequency is above this setting. 0.0–60.0 Hz 6.0
C07-14 Re-Accel Delay If the operator decelerates the hoist then re-
accelerates, Anti-Shock Detection is disabled
for this period of time. 0.00–2.55 sec 0.20
C07-15 Torque Delta Torque increase required to initiate the Anti-
Shock sequence. 0–180% 10
C07-16 Detection Time Time window to detect torque delta (C07-15). 0.01–0.50 sec 0.30
C07-17 Smoothing Freq When the torque increase is detected, the
motor will decelerate to this frequency. 0.0–15.0 Hz 3.0
C07-18 Smoothing Decel Deceleration time once an Anti-Shock event
has been detected. Increase this value in 0.1
sec increments if DEV faults are occurring. 0.00–1.00 sec 0.30
C07-20 Smoothing Time Time window to smooth out the torque. 0.00–2.55 sec 1.00
C07-22 AlarmDisplayTime When Anti-Shock is triggered, an alarm will
display on the keypad screen for the selected
duration of time. 0–30 sec 4
C07-23 No Load Torque Any torque values below this level are
ignored. Best described as the torque level
while hoisting with an empty hook (no load). 0–100% 20
C07-24 Activation Torque In order for Anti-Shock to be triggered, the
torque increase is required to peak above this
percentage. 0–180% 75
C07-25 Detection Method Anti-Shock detection method. 0–2 1
0 Always Detect Anti-Shock can be continuously detected.
1 Once Per Lift After Anti-Shock is detected once during a lift,
it is disabled until the hoist is lowered.
2 Fault on Detect Fault when Anti-Shock is detected.