IMPULSE•G+/VG+ Series 4 Technical Manual
November 2022
Page 119
The switching frequency (D04-07) can also be controlled with a digital input programmed to “ASR gain switch”
(H01-xx = 37). When the digital input is OFF, the VFD uses the ASR gain level set by the pattern in
.
When the digital input is ON, D04-03 is used. The integral time set to D04-02 is used to change linearly between
these settings, as shown in
. The ASR gain enabled by a digital input overrides the switching frequency
set to D04-07.
Figure 5-20: ASR Proportional Gain Switch
5.3.5 Torque Control
Please consult factory for application assistance regarding torque control. Typically, torque control should not be
applied on a hoist.
This function is used to avoid excessive changes in torque, which may be caused by abnormal resonance when
the torque reference changes rapidly.
Table 5-49: Torque Control Parameter Settings
* Cannot set D05-01 = 1 for NLB Hoist; use Load Share MFDI (H01-xx = 66) instead.
Parameter
Display
Function
Range
Default
D05-01
Torq Control Sel
Selects between Speed or Torque Control.
0, 1
0
0 Speed Control
Speed Control enabled with torque limit.
1 Torque Control*
Torque control enabled with speed limit.
D05-02
Torque Ref Filter
Primary delay time for Torque Reference Input.
0–1000 ms
0
D05-03
Speed Limit Sel
Speed Limit Selection (
1, 2
2
1 Fref Limit
Limit set by the frequency reference in B01-01.
2 Speed Limit Sel
Limit set by D05-04.
D05-04
Speed Lmt Value
Speed Limit Value (% of E01-04)
-120–120%
105
D05-05
Speed Lmt Bias
Speed Limit Bias (% of E01-04)
0–120%
10
D05-06
Ref Hold Time
Speed/Torque Switching Timer
0–1000 ms
0
D05-08
Drctn SpdLmt Sel
Determines if the speed limit bias is applied.
0, 1
1
0 Disabled
1 Enabled
Содержание Impulse G+ series 4
