Magnetek Impulse G+ series 4, Техническое руководство, Страница: 182 / 248

IMPULSE•G+/VG+ Series 4 Technical Manual
November 2022
Page 182
A successful COPY of the parameter values will display:
If an error is displayed, press any key to return to parameter O04-01. Error displays and their meanings are
covered in
Table 6-7 on page 215
.
It is possible to compare the parameter values stored in the keypad with the parameter values currently in the VFD
by using the VERIFY function. This VERIFY function should not be confused with the “-VERIFY-” that is displayed
on the keypad when viewing the “Modified Parameters” menu. To VERIFY the parameter values in the VFD as
compared with those stored in the keypad, set O04-01 = 3 (OP
↔
INV VERIFY). During the comparison, the keypad
will display:
A successful VERIFY of the parameter values will display:
If the parameters stored in the keypad do not match those programmed in the VFD, the keypad displays the
following:
The keypad will not display which parameters did not match, only that the verification found discrepancies in some
parameter values.
NOTE:
In order to properly use the COPY or VERIFY functions, the following VFD information must be identical
between the VFD that the parameters were read from and the VFD that the parameters are written to:
Model Number (e.g., 5001-G+ S4)
Firmware Version (e.g., 14707)
Control Method (e.g., Flux Vector)
Motion (e.g., NLB Hoist)
NOTE: See Section 6.5 on page 215
for additional copy function troubleshooting.