214685
31
Revision A
Chapter 4:
Setting up Float Module
Complete the following procedures in the order in which they are listed:
•
4.1 Installing Filler Cap, page 31
•
4.2 Float Module Feed Auger Configurations, page 34
•
4.3 Float Module Stripper Bars and Feed Deflectors, page 58
4.1
Installing Filler Cap
Figure 4.1: Hardware Bag
1.
Remove filler cap from bag (A).
Figure 4.2: Yellow Shipping Cover
CAUTION
Fluid may be under pressure. Allow pressure to equalize
by loosening screws and lifting the shipping cover
slightly.
2.
Remove yellow shipping cover (A) from the float module
frame. Discard cover. Keep screws if screws are not
supplied with filler cap.
Содержание FlexDraper FD1 Series
