214685
121
Revision A
Figure 6.26: Torque Wrench
14. Push down on the wrench until indicator (A) reaches a
maximum reading and then begins to decrease. Note
the maximum reading. Repeat at opposite side.
15. Use the following table as a guide for float settings:
•
If reading on the wrench is high, the header is heavy
•
If reading on the wrench is low, the header is light
Table 6.2 Float Settings
Header Size
Indicator Reading
Cutting on the Ground
Cutting off the Ground
9.1 m and 10.7 m (30 ft. and 35 ft.)
1-1/2 to 2
2 to 2-1/2
12.2 m and 13.7 m (40 ft. and 45 ft.)
2 to 2-1/2
2-1/2 to 3
Figure 6.27: Float Adjustment (Left Side Shown)
16. Before adjusting the float spring adjustment bolts (A),
rotate the spring locks (B) by loosening bolts (C).
17. To increase float (decrease header weight), turn both
adjustment bolts (A) on the left side clockwise. Repeat
adjustment at opposite side.
NOTE:
Turn each bolt pair equally.
18. To decrease float (increase header weight), turn left
side adjustment bolts (A) counterclockwise. Repeat at
opposite side.
NOTE:
Turn each bolt pair equally.
19. Adjust the float so the wrench readings are equal on
both sides of the header.
NOTE:
For 12.2 and 13.7 m (40 and 45 ft.) double-knife
headers:
adjust the float so the wrench readings are
equal at both sides, and then loosen both right side
spring bolts two turns.
20. Lock adjustment bolts (A) with spring locks (B). Ensure
bolt heads (A) are engaged in the spring lock cutouts.
Tighten bolts (C) to secure spring locks in place.
21. Proceed to
6.11.2 Adjusting Wing Balance, page 128
.
Содержание FlexDraper FD1 Series
