214685
44
Revision A
Figure 4.29: Right Side of Medium
Configuration
2.
Remove bolts (A) and access cover (B). Retain for
reassembly.
3.
Remove hardware from locations (C), and remove
bolt-on flighting (D) from the feed auger.
Figure 4.30: Right Side of Wide Configuration
4.
Install flighting slot plug (A) (MD #213084) in the
flighting slot from inside the auger. Secure with M6 hex
head bolts (B) (MD #252703) and tee nuts
(MD #197263).
5.
Repeat above steps at the left side of the auger.
6.
Install additional fingers. A total of 30 fingers are
recommended for this configuration. Refer to
Installing Feed Auger Fingers, page 54
.
Содержание FlexDraper FD1 Series
