214685
78
Revision A
Figure 5.40: Combine Auxiliary Power Supply
12. Connect the harness end to one of the auxiliary power
supply points (A).
13. Connect the wire (from the in-line fuse) to the switched
power supply (C).
14. Connect the other wire to ground (B).
IMPORTANT:
Connecting the switch harness to an unswitched power
supply or cigarette lighter will supply constant power to
the header tilt side of the solenoid valve and drain the
combine battery during extended shutdown periods.
15. Tape unused wire jumpers to harness.
Figure 5.41: Plug End of Harness
16. Route plug end of harness (A) through hole (B) in cab
floor, and feed the entire length outside the cab. Leave
some slack in the cab to allow for console adjustment.
17. Reinstall floor mat.
Содержание FlexDraper FD1 Series
