214685
270
Revision A
Figure 7.253: Combine Display
3.
Select AUTO HEIGHT SENSING (A), RETURN TO
CUT (B), and REEL POSITION (C) icons.
NOTE:
If REEL POSITION icon (C) cannot be selected (no
check mark), the reel height sensor requires calibration.
Refer to
Calibrating Reel Height Sensor (John Deere S
Figure 7.254: Combine Control Console
4.
Engage the header.
5.
Move header to desired position and use knob (A) to
fine tune position.
6.
Move reel to desired position.
Figure 7.255: Control Handle Buttons
7.
Press and hold preset switch 2 (B) until 1 reel height
icon flashes on monitor.
8.
Repeat previous three steps for preset switch 3 (C).
9.
Select an appropriate ground pressure setting. Use
preset button 2 (B) on the control handle for a low
ground pressure setting in muddy or soft soil conditions,
and preset 3 (C) for a high ground pressure setting in
firm soil conditions and a higher ground speed.
NOTE:
Preset button 1 (A) is reserved for header lift on the
headland and is not used for cutting on ground.
Содержание FlexDraper FD1 Series
