![background image](http://html2.mh-extra.com/html/macdon/flexdraper-fd1-series/flexdraper-fd1-series_unloading-and-assembly-instructions_3353032288.webp)
214685
276
Revision A
Figure 7.270: John Deere Combine Display
8.
Raise the reel to view the high voltage (A). The voltage
should be 4.1
–
4.5 V.
9.
If either voltage is not within the correct range, refer to .
Calibrating Reel Height Sensor (John Deere S and T Series)
This procedure applies only to model year 2015 and later John Deere S and T Series combines.
NOTE:
Changes may have been made to the combine controls or display since this document was published. Refer to the
combine operator
’
s manual for updates.
To calibrate reel height, follow these steps:
1.
Place header off the ground 15
–
25 cm (6
–
10 in.).
Figure 7.271: John Deere Combine Display
2.
Press DIAGNOSTIC icon (A) on the main screen of the
monitor. The CALIBRATION screen displays.
Содержание FlexDraper FD1 Series
