214685
65
Revision A
Figure 5.9: Float Module
CAUTION
Never start or move the machine until you are sure all
bystanders have cleared the area.
2.
Start the engine and slowly approach the header until
the feeder house is directly under the float module top
cross member (A) and the alignment pins (C) (refer to
Figure
) on the feeder house are aligned
with the holes (B) in the float module frame.
Figure 5.10: AGCO Group Alignment Pins
NOTE:
Your combine feeder house may not be exactly
as shown.
Figure 5.11: Feeder House and Float Module
3.
Raise the feeder house slightly to lift the header,
ensuring the feeder house saddle (A) is properly
engaged in the float module frame.
4.
Stop the engine and remove the key from the ignition.
Содержание FlexDraper FD1 Series
