214685
316
Revision A
Figure 8.1: Reel Height Sensor
–
Right Reel Arm
(Reel Down)
3.
Use the combine display or a voltmeter (if measuring
the sensor manually) to measure voltage range
Y
. Refer
to Table
for range requirements.
4.
If using a voltmeter, measure the voltage between the
ground (Pin 2 wire) and the signal (Pin 3 wire) at the
reel height sensor (B).
5.
Stop the engine and remove key.
6.
Adjust length of threaded rod (A) to modify voltage
range
Y
.
7.
Repeat checking and adjusting until voltage range
Y
is
within the range specified.
Figure 8.2: Reel Height Sensor
–
Right Reel Arm
(Reel Up)
8.
Start the engine, and fully raise the reel.
9.
Use the combine display or a voltmeter (if measuring
the sensor manually), to measure voltage range
X
.
Refer to Table
for range requirements.
10. If using a voltmeter, measure the voltage between the
ground (Pin 2 wire) and the signal (Pin 3 wire) at the
reel height sensor (A).
11. Stop the engine and remove the key.
12. Loosen two M5 hex nuts (B) and rotate sensor (A) to
achieve voltage range
X
.
13. Repeat checking and adjusting until voltage range
X
is
within the range specified.
14. Start the engine and fully lower the reel.
15. Recheck voltage range
Y
and ensure it is still within the
range specified. Adjust if required.
Содержание FlexDraper FD1 Series
