214685
222
Revision A
Figure 7.154: CLAAS Combine Display and
Console
1.
Use HOTKEY rotary dial (A) to select REEL icon (B).
Figure 7.155: CLAAS Combine Display and
Console
2.
Use control knob (A) to select AUTO REEL HEIGHT
icon (B) at the top of the page.
NOTE:
The AUTO REEL HEIGHT icon (C) at the center of the
page should be highlighted black. If it is not black, either
the end stops have not been set or the AHHC is not
active. For instructions, refer to
Sensor (CLAAS 600 and 700 Series), page 219
Figure 7.156: CLAAS Combine Display and
Console
3.
Adjust the auto reel height position for the current
AHHC position using outer scroll knob (A). To lower the
preset reel position, turn the scroll knob
counterclockwise; to raise the preset reel position, turn
the scroll knob clockwise. The display will update the
current setting (B).
NOTE:
If the AUTO REEL HEIGHT icon in the center of the
page is not black, an AHHC position is not currently
active.
Содержание FlexDraper FD1 Series
