214685
29
Revision A
Figure 3.26: Gearbox End of Driveline
3.
At gearbox end, remove driveline shield (A) by
loosening nuts (B).
4.
Position the driveline quick disconnect onto the float
module gearbox shaft, pull back the collar, and slide
onto the shaft until the yoke locks on to the shaft.
Release the collar.
5.
Position the shield (A) on the gearbox and secure with
bolts (B).
6.
Attach driveline chain (C) to existing chain on shield (A).
Figure 3.27: Driveline in Storage Position
7.
Position the combine end of the driveline (A) onto
storage support (B), pull back the collar, and slide onto
the shaft until the yoke locks on to the shaft. Release
the collar.
8.
Secure loose end of driveline chain (C) to driveline
storage support (B).
Figure 3.28: Driveline in Storage Position
–
Case New Holland
Содержание FlexDraper FD1 Series
