214685
266
Revision A
Figure 7.242: John Deere Combine Display
9.
Select HEADER (A) from the list of calibration options.
Figure 7.243: John Deere Combine Display
10. With HEADER selected, press icon (A). The icon will
turn green.
Figure 7.244: John Deere Combine Display
11. Click button (A) and instructions will appear on screen
to guide you through the remaining calibration steps.
NOTE:
If an error code appears during calibration, the sensor is
out of voltage range and will require adjustment. Refer
to
Checking Voltage Range from the Combine Cab
(John Deere S and T Series), page 261
NOTE:
If float was set heavier to complete the AHHC
calibration procedure, adjust to recommended
operating float after the calibration is complete.
Содержание FlexDraper FD1 Series
