214685
54
Revision A
4.2.10
Installing Feed Auger Fingers
DANGER
To avoid bodily injury or death from unexpected start-up or fall of a raised machine, always stop engine
and remove key before leaving the operator
’
s seat, and always engage safety props before going under
the machine for any reason.
NOTE:
Not all parts needed for this procedure are included in this kit, and depending on the original configuration of the
feed auger, additional parts may need to be ordered. Refer to
4.2 Float Module Feed Auger Configurations, page
to see which parts are available.
Figure 4.52: Access Hole Cover
1.
Remove bolts (A) and access cover (B) from the access
cutout closest to the finger that needs to be installed or
replaced.
Figure 4.53: Auger Finger Hole
2.
Remove the two bolts (B), tee nuts, and plug (A).
Содержание FlexDraper FD1 Series
