214685
217
Revision A
Figure 7.142: CLAAS Combine Display,
Console, and Control Handle
3.
Select the FRONT ATTACHMENT PARAMETER
SETTINGS icon (A). A list of settings appears.
4.
Select SENSITIVITY CAC (B) from the list.
Figure 7.143: CLAAS Combine Display
5.
Select the SENSITIVITY CAC icon (A).
NOTE:
To set the sensitivity, you will have to change the
CUTTING HEIGHT ADJUSTMENT (B) from the 0
default. The settings from 1
–
50 provide a faster
response, whereas the settings from -1 to -50 provide a
slower response. For best results, make adjustments in
increments of five.
6.
Increase the CUTTING HEIGHT ADJUSTMENT setting
if the reaction time between the header and the float
module is too slow while cutting on the ground, and
decrease the CUTTING HEIGHT ADJUSTMENT setting
if the reaction time between the header and the float
module is too fast.
7.
Increase the sensitivity if the header is lowered too
slowly, and decrease the sensitivity if the header hits
the ground too hard or is lowered too quickly.
Содержание FlexDraper FD1 Series
