MacDon FlexDraper FD1 Series, Инструкции по разгрузке и сборке

Страница: 155 / 354

214685
143
Revision A
6.16.2 Lubrication Points
Knifehead
Figure 6.69: Knifehead
Single Knife
–
One Place Double Knife
–
Two Places
IMPORTANT:
Overgreasing can cause the knife to bend and make
contact with the guards closest to the knifehead. Check for
signs of excessive heating on first few guards after
greasing. If required, relieve some pressure by removing
the grease fitting.
•
To prevent binding and/or excessive wear caused by
knife pressing on guards, do
NOT overgrease the
knifehead (A).
•
Apply only 1
–
2 pumps of grease with a grease gun, or
just until the knifehead starts to move away from the
arm. Do
NOT use an electric grease gun.
•
If more than 6
–
8 pumps of the grease gun are required
to fill the cavity, replace the seal in the knifehead.
•
Check for signs of excessive heating on first few guards
after greasing. If required, relieve pressure by pressing
check-ball in grease fitting.
NOTE:
Use high temperature extreme pressure (EP2) performance
with 1% max molybdenum disulphide (NLGI Grade 2) lithium
base grease unless otherwise specified.
PERFORMING PREDELIVERY CHECKS