214685
48
Revision A
Figure 4.37: Wide Configuration (Right Side)
6.
Converting from Wide configuration:
Remove
bolts (A), access cover (B), and two flighting slot
plugs (C) from the right side of the auger.
7.
Repeat Steps
to
at the left side of
the auger.
Figure 4.38: Right Side of Auger
8.
Position two bolt-on flightings (A) on the right side, as
shown. Temporarily secure flightings with two carriage
head bolts and nuts at each location (B).
Figure 4.39: Right Side of Auger
9.
Position another bolt-on flighting (A) outboard of the
temporarily installed flighting (B). Mark hole
locations (C) of the bolt-on flighting onto the temporarily
installed bolt-on flighting (B).
10. Remove temporarily installed bolt-on flighting (B) from
the auger and drill two 11 mm (7/16 in.) holes at the
marked locations.
11. Install the bolt-on flighting (B) with newly drilled holes
using six carriage head bolts and nuts.
IMPORTANT:
Carriage bolt heads must be installed on inside of auger
to prevent damage to internal components.
12. Repeat Steps
to
to the
remaining bolt-on flighting on the right side of the auger.
Содержание FlexDraper FD1 Series
