214685
110
Revision A
Figure 6.7: Knife Drive Box
IMPORTANT:
The knife drive box breather is shipped in position (A)
(forward) to prevent oil loss during transport. The
breather
MUST
be repositioned to location (B) to prevent
oil loss during normal operation. Failure to do so can
result in damage to the knife drive box.
4.
Check position of plug (A) and breather (B) at knife
drive box. Position
MUST
be as shown.
5.
Remove breather (B) and check oil level. The oil level
should be between the bottom edge (C) of the lower
hole (D) and the bottom (E) of the breather.
NOTE:
Check oil level with top of knife drive box horizontal and
with the breather (B) screwed in.
6.
Reinstall breather and tighten.
Содержание FlexDraper FD1 Series
