MacDon FlexDraper FD1 Series, Инструкции по разгрузке и сборке

Страница: 70 / 354

214685
58
Revision A
4.3 Float Module Stripper Bars and Feed Deflectors
4.3.1 Removing Stripper Bars
Stripper bar kits may have been supplied with your header to improve feeding in certain crops such as rice. They
are
NOT recommended for cereal crops.
NOTE:
The following procedure does NOT apply to New Holland CR960, 9060, 970, 9070, and 9080 combines. For these
combines, refer to
4.3.2 CR Feeder Deflectors, page 58 .
If necessary, remove auger stripper bars as follows:
Figure 4.62: Auger Stripper Bar
1. Remove four bolts (A) and nuts securing bars (B) to
adapter frame. Remove bars.
2. Repeat for opposite set of stripper bars.
4.3.2 CR Feeder Deflectors
For New Holland combines only: Short feeder deflectors have been factory-installed on the float module to
improve feeding into the feeder house. Remove the feeder deflectors if necessary. Refer to 4.3.3 Replacing Feed
Deflectors on New Holland CR Combines, page 59 .
Long feeder kits are provided for narrow feeder house combines and can be installed to replace the short
feeder deflectors.
Feeder House Size Feeder Kit Size MacDon Part Number
1250
–
1350 mm (49
–
65 in.) Short: 200 mm (7-7/8 in.) MD #213613, 213614
1100 mm (43-1/2 in.) and below Long: 325 mm (12-13/16 in.) MD #213592, 213593
SETTING UP FLOAT MODULE