Lenovo Flex System x220, Инструкция по установке и обслуживанию

Страница: 694 / 714

remove the Tag from the lower right corner of the old bezel and install it on the lower right corner
of the new bezel that shipped with the new system-board assembly; then, install the new bezel
on the new system-board assembly.
RID Tag
3. Install RID tag 1 on labeling tab, RID tag 2 on bottom of
compute node, and RID tag 3 on low right-hand corner of
new bezel
After you install the system-board assembly, complete the following steps:
1. Install the cover onto the compute node (see “Installing the compute node cover” on page 644 for
instructions).
2. Install the compute node into the chassis (see “Installing a compute node in a chassis” on page 639
for instructions).
3. Use the CMM Web Interface to restore the IP address of the compute node IMM. See
Starting the web interface in the "Flex System Chassis Management Module: User's Guide" at
http://pic.dhe.ibm.com/infocenter/flexsys/information/topic/com.lenovo.acc.cmm.doc/cmm_ug_
startwebinterface.html for more information.
Note: If you configured static IP addresses, you will not be able to access the node remotely or from the
FSM until the IP address of the IMM is restored.
4. If any Features on Demand (FOD) features are installed in the compute node, see the instructions in
the Features on Demand User's Guide to reactivate these features. To download this document, go to
http://www.ibm.com/systems/x/fod/, log in, and click Help .
5. Update the Universal Unique Identifier (UUID) and the Vital Product Data (VPD). Use the Advanced
Settings Utility to update the UUID and VPD in the UEFI-based compute node (see “Updating the
Universally Unique Identifier and DMI/SMBIOS data” on page 30).
6. Update the compute node with the latest firmware or restore the preexisting firmware (see “Updating
firmware and device drivers” on page 21 for more information).
686
Flex System x220 Compute Node Installation and Service Guide