Lenovo Flex System x220, Инструкция по установке и обслуживанию

Страница: 43 / 714

Step 7. On the Select Drives screen, scroll down to Choose Unconfigured Drives and highlight the drive
you want to use. Press the spacebar to select the drive. An X appears to indicate that the drive has
been selected. Repeat this step for the second drive if you are configuring a RAID1 array.
Step 8. On the Select Drives screen, select Apply Changes to create the array.
Step 9. When the
Success
prompt is displayed, select OK to continue.
Step 10. After the system returns to the Create Configuration screen, select Save Configuration .
Notes:
1. You must save the virtual drive configuration before exiting the Setup utility.
2. If you return to the Select Drives screen, your drive selections will be deleted.
Step 11. When the prompt
Creating Virtual Drives will cause the data lost on the associated Drives to be
permanently deleted.
is displayed, select Yes to continue.
Step 12. When the
Success
prompt is displayed, select OK to continue.
Step 13. RAID1 only: To initialize the virtual disk, select ServeRAID C105 > Virtual Drive Management >
Select Virtual Drive Operations .
Note: These steps are not required for RAID0.
a. Under Virtual Drive Operation , choose Select Operation . Select the type of initialization
you want to use.
b. Select Start Operation .
c. Select Yes to confirm.
d. When the
Success
prompt is displayed, select OK to continue.
1. For more information about ServeRAID C105, see https://support.lenovo.com/us/en/
documents/MIGR-5073015.
2. ServeRAID C105 is not supported in VMware 5 and VMware 4.1.
3. ServeRAID C105 is not supported in solid-state drives.
4. ServeRAID C105 is not supported in legacy configuration.
5. ServeRAID C105 is automatically disabled when ServeRAID H1135 is installed.
Creating an array using the optional ServeRAID H1135 controller
Use these instructions to configure a RAID array on the Flex System x220 Compute Node using an optional
ServeRAID H1135 controller.
To configure the optional ServeRAID H1135 controller, use the LSI SAS2 MPT Controller Configuration
application to perform the following tasks:
• Set the device boot order
• Add or remove devices from the boot list
• Manage the RAID configuration
Note: The hard disk drives in the RAID configuration must use the same type of interface and must have
identical capacity and speed.
To start the application, complete the following steps.
Step 1. Start the compute node Setup utility. See “Using the Setup utility” on page 24 for instructions.
Step 2. From the Setup utility main menu, select System Settings .
The following illustration shows the Setup utility main menu.
Chapter 2
.
Configuring
35