Lenovo Flex System x220, Инструкция по установке и обслуживанию

Страница: 32 / 714

Step 4. Configure the integrated management module II (IMM2), using the Setup utility or the Advanced
Settings Utility (ASU).
Step 5. Update the compute node firmware (see “Updating firmware and device drivers” on page 21).
• If you use Flex System Manager Update Manager to update the firmware, you can optionally
start the operating-system installation while the firmware updates are installed. It is normal
operation for the initial firmware updates to take an unusual length of time.
• If the Chassis Management Module (CMM) and the compute nodes are set up to use DHCP and
the CMM loses connectivity to the network, the CMM attempts to acquire a new IP address
when network connectivity is restored. The compute nodes will not attempt to acquire an IP
address again; they will continue to use their original IP addresses. Therefore, if you experience
network problems on compute nodes after connectivity between the CMM and the network is
restored, you might have to reset the system-management processor in each of the compute
nodes in the chassis (including the management node). See “Connectivity problems” on page
615 for more information.
After you configure the compute node, you can install the operating system and update device drivers (see
Chapter 3 “Installing the operating system” on page 43 for more information).
Using the Setup utility
Use these instructions to start the Setup utility.
You can also access the Setup utility remotely through the CMM web interface.
From the CMM web interface, select
Launch Compute Node Console . For more
information, see the the "Flex System Chassis Management Module: User's Guide" at
http://pic.dhe.ibm.com/infocenter/flexsys/information/topic/com.lenovo.acc.cmm.doc/ cmm_user_
guide.html. All fields and options are described in the CMM web interface online help.
To start the Setup utility locally, complete the following steps.
Step 1. If the compute node is turned on, turn off the compute node (see “Turning off the compute
node” on page 16).
Step 2. If necessary, connect a keyboard, monitor, and mouse to the console breakout cable and connect
the console breakout cable to the compute node.
Step 3. Turn on the compute node (see “Turning on the compute node” on page 15).
Step 4. When the prompt
Press <F1> Setup
is displayed, press F1. If you have set an administrator
password, you must type the administrator password to access the full Setup utility menu. If you
do not type the administrator password, a limited Setup utility menu is available.
Step 5. Follow the instructions on the screen.
The following menu items are on the Setup utility main menu. Depending on the version of the Unified
Extensible Firmware Interface (UEFI), some menu items might differ slightly from these descriptions.
• System Information
Select this choice to view information about the compute node. When you make changes through other
choices in the Setup utility, some of those changes are reflected in the system information; you cannot
change settings directly in the system information. This choice is on the full Setup utility menu only.
– System Summary
Select this choice to view configuration information, including the ID, speed, and cache size of the
microprocessors, machine type and model of the compute node, the serial number, the system
Universally Unique Identifier (UUID), and the amount of installed memory.
– Product Data
24
Flex System x220 Compute Node Installation and Service Guide