Kongsberg cJoy OT, Руководство оператора

Страница: 67 / 208

Message system
• If the message has been reported as inactive, it is removed from the Message
line and replaced by the next most recent active Emergency, Alarm or Warning
message.
Message view
To acknowledge the unacknowledged messages currently visible in the Message view,
proceed as follows:
1 Press the Alarms button.
• The Message view is displayed.
2 If the audible signal horn is not sounding, press the
Silence/ack.
button once to
acknowledge the visible messages.
• All inactive acknowledged Emergency, Alarm and Warning messages together
with any Information messages are removed from the view.
• If there are further unacknowledged messages, the view is refreshed and refilled
with active messages.
• If all active messages have been acknowledged, the flashing red alarm indicator
above the Silence/ack. button extinguishes (becomes unlit).
3 If the audible signal horn is sounding, press the
Silence/ack.
button twice with a
delay of at least 2 seconds between each press.
• The first press silences the audible signal.
• The second press acknowledges all visible unacknowledged messages.
• All inactive acknowledged Emergency, Alarm and Warning messages together
with any information messages are removed from the view.
• If there are further unacknowledged messages, the view is refreshed and refilled
with active messages.
• If all active messages have been acknowledged, the flashing red alarm indicator
above the
Silence/ack.
button extinguishes (becomes unlit).
4
If the red alarm indicator above the
Silence/ack.
button is still flashing, repeat step
2 as many times as required, until it changes to steadily lit.
5
Press the
Alarms
or
Cancel
button.
• The Message view is closed.
Alarm indicator
This red alarm indicator above the Silence/ack. button flashes in response to a
software-generated alarm or warning from the operator terminal microprocessor initiated
by an operational alarm or warning condition; for example, heading or position deviation
beyond limits or sensor error. These alarms are generated by a controller PS or another
alarm originator (such as the equipment monitoring system) and do not indicate failures
in the operator terminal.
385585/C
67