Komatsu WA380-8, Руководство по эксплуатации и техническому обслуживанию

Страница: 344 / 432

REMARK
You cannot measure the exact oil level until 12 hours elapses after the engine is stopped because the oil
remains in various parts.
2.
Remove the cap of oil filler port (F).
3.
Pull out dipstick (G) and wipe the oil off with a cloth.
4.
Fully insert dipstick (G) into the dipstick pipe, then remove
it.
REMARK
Whenever inserting the dipstick, be sure to insert it into the
dipstick pipe.
The oil level should be between the H and L marks on dip-
stick (G).
5.
If the oil level is below the L mark, add oil through oil filler
port (F).
The following levels are marked on the dipstick.
(A): ENG STOP (Engine is stopped)
(B): ENG LOW IDLE (Engine is running at low idle)
6.
If the oil level is higher than mark H, do as follows.
1) Remove inspection window (1) of the undercover.
2) Drain the excessive oil through drain plug (P).
3) Check the oil level again.
7.
If the oil is at the correct level, insert dipstick (G) in the dip-
stick pipe and tighten the oil filler cap.
Checking of the oil level must be done at “ENG STOP” position after 12 hours or more elapsed after the engine
is stopped.
The check can also be performed while the engine is running at low idle. Perform the check as follows.
• When the machine is continuously operated (check during lunch time or check at replacement)
MAINTENANCE PROCEDURE MAINTENANCE
4-24