KI WireWorks, Руководство по сборке

Страница: 21 / 48

WireWorks
®
Panel System
Assembly Instructions
Assemble units as described herein only. To do otherwise
may result in instability. All screws, nuts and bolts must be
tightened securely and must be checked periodically after
assembly. Failure to assemble properly, or to secure parts
may result in assembly failure and personal injury.
19
Installing Receptacles at Other
Heights
WARNING: Assembly of all
mechanical frame components
must be completed before
making any electrical
connections. All electrically
connected furnishings must also
be mechanically connected.
Installing receptacles at heights
other than in the base raceway,
requires raceway tiles. Raceway
tiles have a painted steel or
fabric-wrapped steel face.
1. Determine the position at which
the receptacle will be installed
and ensure a rigid wireway is
already mounted behind the
raceway tile. (See page 15)
2. Remove the raceway tile from
the panel and snap the bezel into
place from the front of the tile
(note “this end up” orientation of
bezel) (Figure 24).
Note: Bezel filler plates always
occupy the upper of the two
openings on raceway tiles. The
bezel filler plate is snapped in
place so that it is flush with the
bezel face.
3. Install the appropriate receptacle
into the rigid wireway behind
the location where the bezel is
located using the same procedure
shown on page 18.
4. Hang the raceway tile on the
top hooks, then allow the tile to
rotate down and snap the lower
portion of the raceway tile into
place by applying firm pressure
near the location of the hooks
(Figure 25).