KI WireWorks, Руководство по сборке

Страница: 38 / 48

36
WireWorks
®
Panel System
Assembly Instructions
Assemble units as described herein only. To do otherwise
may result in instability. All screws, nuts and bolts must be
tightened securely and must be checked periodically after
assembly. Failure to assemble properly, or to secure parts
may result in assembly failure and personal injury.
Hanging Open and Window
Tiles
Open and window tiles consist
of two separate tiles that hang
back-to-back. The first tile either
supports the glass on a window
tile or a thin plastic extrusion for
the open tile. The second tile is
the same for the window and the
open tile and consists of a painted
aluminum trim frame. Both halves
of the open and window tiles are
hung like acoustic tiles, except
eight hooks are used per side
instead of four. The extra hooks are
installed just above the lower two
hooks and just below the upper
two hooks.
1. With the tile hooks already in
place on the frame (See Installing
Tile Hooks on page 14), hang
the tile on the top four hooks
(Figure 55).
2. Hold the top of the tile against
the frame and gently lift up on the
bottom of the tile while pushing it
in toward the frame to engage the
hooks. Let the tile slide down into
position while continuing to
support it against the frame
(Figure 56).
3. After the tile is hung, pull the tile
away from the frame on the four
corners to ensure that all eight
hooks are engaged.
4. Install each supplied dislodgment
insert into the horizontal above
the window using a #3 Phillips
head screwdriver (Figure 57).
Two inserts are used per window
or open tile.
Note: Tiles can be rotated and
still hung on the panel frame. For
example, a 24” x 24” tile can be
hung with any edge as the top.