KI WireWorks, Руководство по сборке

Страница: 17 / 48

WireWorks
®
Panel System
Assembly Instructions
Assemble units as described herein only. To do otherwise
may result in instability. All screws, nuts and bolts must be
tightened securely and must be checked periodically after
assembly. Failure to assemble properly, or to secure parts
may result in assembly failure and personal injury.
15
WARNING: Assembly of all
mechanical frame components
must be completed before
making any electrical
connections. All electrically
connected furnishings
must also be mechanically
connected.
Product Overview
KI’s “810” 10-wire electrical
system is available in two
versions: a six-circuit system
(622) and a four-circuit
system (442). They are not
interchangeable and are
differentiated by the color of the
UL label; 622 is green and 442
is blue.
Installing Rigid Wireway
Rigid wireways are installed
by first installing the plastic
clips into the appropriate slot
on the horizontal rail. Slide the
clips near side open saddles
(Figure 16) on to the frame until
a snap is heard. Then squeeze
frame until the far side saddles
engage the rail and affix in place
manually, or with a soft mallet.
Rigid wireways hang off the
lowest rail (base power)
(Figure 16) but sit on top of
the rails at other heights (ADA,
worksurface height and standing
height) (Figure 17).
1. Orient the wireway so the
N
symbol points toward the top of
the panel (Figure 18). For base
power, position the rigid wireway
below the horizontal rail, insert
plastic clips as stated above.
Then, align the steel mounting
brackets to the two holes in the
plastic clips and insert one
#10-24 x
3
/
8
” screw from each
side, on both ends (Detail D).
2. For power at other heights,
position the plastic clips on the
top of the horizontal rail
(Figure 17). Continue installing
rigid wireways as required.
Hint: To remove the wireway,
insert a screwdriver into the
mounting slot of the horizontal
rail until the clip can be pulled
free (Figure 18) or remove all
four screws