KI WireWorks, Руководство по сборке

Страница: 18 / 48

16
WireWorks
®
Panel System
Assembly Instructions
Assemble units as described herein only. To do otherwise
may result in instability. All screws, nuts and bolts must be
tightened securely and must be checked periodically after
assembly. Failure to assemble properly, or to secure parts
may result in assembly failure and personal injury.
Installing Horizontal Jumper
WARNING: Assembly of all
mechanical frame components
must be completed before
making any electrical
connections. All electrically
connected furnishings must also
be mechanically connected.
Power is passed from panel
to panel by using a horizontal
jumper (Figure 19). Horizontal
jumpers use a plastic mesh
sheathing and come in two
lengths (17” and 20”). The 17”
jumpers are used on inline
conditions, while 20” jumpers
are used to pass straight through
an intersection or around a 90°
corner. See examples A-E for
typical installations.
1. Jumpers plug into one of two
open sockets on each end of the
rigid wireway. Orient the jumper
so the
N
symbol is pointing up.
Slide the jumper into an open
socket until the end fully seats in
the metal wireway tab.
Removing Horizontal Jumper
1. To remove a jumper, pull slightly
on the steel tabs on the wireway
until the jumper can be pulled
from the socket.
Note: Horizontal jumpers will
pass behind raceway tiles,
but they will not pass behind
acoustical tiles.
Typical horizontal jumper
installations are shown in
examples A-E.