20
WireWorks
®
Panel System
Assembly Instructions
Assemble units as described herein only. To do otherwise
may result in instability. All screws, nuts and bolts must be
tightened securely and must be checked periodically after
assembly. Failure to assemble properly, or to secure parts
may result in assembly failure and personal injury.
Installing Base Raceway
Base Raceways consist of the
raceway, base locks and filler
plates (panels 24” and wider
only).
1. Slide the base raceway into place
under the panel with the doors
lying in the open position. When
the raceway is centered under the
panel around the glides, snap the
trim up over the lip on the glide
housings (Figure 26).
Note:
Base raceway installation
is made easier if all glides have
been turned down at least
1
/
4
”.
2. Push each base cover lock away
from the center of the panel until
the plunger pops down into the
locked position (Figure 27).
To ensure the lock is engaged,
press inward on the lock. It may
be necessary to press down on
the plunger to ensure the lock
engages.
3. Rotate the doors of the base
raceway upward until they engage
the lower horizontal (Figure 28).
The base cover steel knock-outs
remain in position unless a
receptacle is being used in that
location. If there is a receptacle
required, prior to rotating the
base raceway door closed, see
Receptacle/Bezel Installation,
page 18.
4. To fill the position of a previously
removed raceway knock-out, use
a blank bezel. Position the blank
bezel with hook facing up, and
first rotate the top hook into the
opening in the base raceway, then
snap the bottom into position to
secure (Figure 29).
WireWorks_page20_art_a.cdr
Figure 26
Figure 27
Figure 28
Figure 28
Figure 29
Figure 29
base raceway
door
base raceway
door
base raceway
door
base raceway
door
plunger
base
cover lock
cover
engages
horizontal
cover
engages
horizontal
bottom
horizontal rail
bottom
horizontal rail
bottom
horizontal rail
base raceway
lock
(46.0053)
lip
of glide
housing
blank bezel
(back-side)
blank
bezel
base
raceway
1
2
Installing Base Raceway
Base Raceways consist of the raceway, base
locks and filler plates (panels 24” and wider
only).
1. Slide the base raceway into place under the
panel with the doors lying in the open position.
When the raceway is centered under the panel
around the glides, snap the trim up over the lip
on the glide housings (Figure 26).
Note: Base raceway installation is made easier if
all glides have been turned down at least 1/4”.
2. Push each base cover lock away from the
center of the panel until the plunger pops down
into the locked position (Figure 27). To ensure
the lock is engaged, press inward on the lock. It
may be necessary to press down on the plunger
to ensure the lock engages.
3. Rotate the doors of the base raceway upward
until they engage the lower horizontal (Figure
28). The base cover steel knock-outs remain in
position unless a receptacle is being used in that
location. If there is a receptacle required, prior to
rotating the base raceway door closed, see
Receptacle/Bezel Installation, page 18.
4. To fill the position of a previously removed
raceway knock-out, use a blank bezel. Position
the blank bezel with hook facing up, and first
rotate the top hook into the opening in the base
raceway, then snap the bottom into position to
secure (Figure 29).
Содержание WireWorks
Страница 1: ...Assembly Instructions WireWorks Panel System January 2020...
Страница 2: ...A...
Страница 46: ...44...
Страница 47: ...45...