B
B
A
A
A
A
A
A
A
A
B
B
B
"B" Positions
"A" Positions
Fig.1
B
G
H
A
I
B
C
F
D
B
C
F
D
E
Detail A
1. Place the bed on a protected surface, with the bottom facing
upward. Place the Enclosure Plate (
A
) on the bed. Mark 14 positions
through the holes in each of pockets.
2. Using an11/32" Drill Bit, drill the 14 holes in the Enclosure Plate.
NOTE:
The Restaint Rings can be located in any position on the bed.
however, recommended locations are shown in (
Fig.1
)
3. Install 6 Restraint Rings (
E
) in the pockets. Top of rings should point
outward as shown (
Detail A
). Install 6 barrel nuts (
D
) through the
restraint rings.
4. Glide assemblies
without
Restraint Rings are to be located at
positions indicated by "A" (
Fig.1
). Restraint Ring/Glide assemblies
should be located at "B" positions.
5. Assemble the components in the sequenece shown
in (
Fig.2
).
Fig.2
Foot
Head
PARTS LIST
ITEM
NO.
PART NUMBER
QTY
DESCRIPTION
A
001-350
1
Plate, Enclosure, Attenda Bed, 84.50" X 40.50"
B
025-010
14
Nut, Hex, 5/16-18 Steel, Zinc
C
025-006
14
Washer, Lock, Split, 3/8, Zinc
D
029-021
14
Nut, Barrel 5/16"-18 X 0.75”L, BH, Pin in Torx® T45, SST
E
029-132
6
Ring, Restraint, Solid Bolt Down, (Optional)
F
026-002
14
Washer, Fender, 11/32" ID x 1-1/4" OD x .050 Zinc
G
029-022
8
Glide 5/16"-18 X 1.5" Hex Collar Stem
H
029-940
6
Glide 5/16"-18 X 2" Hex Collar Stem
I
025-009
8
Washer, Flat, 3/8"
Tools Needed
T40 Driver
T45 Driver
11/32" Drill Bit
Rev. A - 9/20/17
091-901
Page 1 of 1
www.norix.com ● TEL 800 234-4900
Assembly Notes:
Norix is not responsible for any damage due to improper installation. If your shipment does not match the parts list, please contact Norix Customer Service at 800-234-4900.
Norix reserves the right to modify design specifications at any time without an obligation to owners of previously sold products.
___________________________________________________________________________________________________________________________________________________________________________________________________
Restraint Ring/Glides Kit
With Enclosure Plate
Assembly Instructions
Model Number
ATN101-XXX.3
