WireWorks
®
Panel System
Assembly Instructions
Assemble units as described herein only. To do otherwise
may result in instability. All screws, nuts and bolts must be
tightened securely and must be checked periodically after
assembly. Failure to assemble properly, or to secure parts
may result in assembly failure and personal injury.
35
Hanging Raceway Tiles
Raceway tiles have molded-
end pieces to hang onto the
tile hooks.
Note:
Raceway tiles may
be used to cover belt height
power pass thru and not used
for receptacles. These tiles
would not require knockouts to
be removed.
Note:
Raceway tiles 24” and
wider come with a knock-out for
electrical and/or data.
1. Using diagonal pliers (wire
cutters), snip out the four steel
tabs that connect the knockout to
the raceway tile (Detail K). Using
a utility knife or razor blade,
remove the fabric (Detail L).
2. Snap the receptacle/data bezel
into the knock-out to cover the
cut edge of the fabric (Figure 52).
Caution should still be used to
avoid excessive fraying of the
fabric.
Note:
Ensure that bezel is
installed with the correct end up.
Refer to directions on inside of
bezel.
Note:
Ensure filler plate is
installed in the top opening of
bezel for raceway tiles (Detail M).
Note:
Filler plates can be
reversed to allow data cables
to be passed through the bezel.
(Detail N).
3. With the tile hooks already in
place on the frame (See Installing
Tile Hooks on page 14) and the
wire trough installed (see page
29), hang the raceway tile on the
top two hooks (Figure 53).
4. Apply firm consistent pressure to
the lower corners of the raceway
tile until the tile snaps into place
(Figure 54). The lower hooks on
raceway tiles are engaged by a
snapping action.
Note:
Raceway tiles are removed
by swinging bottom of tile out
and away from bottom hooks
before lifting tile up off of top
hooks.
Содержание WireWorks
Страница 1: ...Assembly Instructions WireWorks Panel System January 2020...
Страница 2: ...A...
Страница 46: ...44...
Страница 47: ...45...