40
WireWorks
®
Panel System
Assembly Instructions
Assemble units as described herein only. To do otherwise
may result in instability. All screws, nuts and bolts must be
tightened securely and must be checked periodically after
assembly. Failure to assemble properly, or to secure parts
may result in assembly failure and personal injury.
Installing In-Line Height
Change Trim
In-line height change trim is
installed over the exposed portion
of a full post in an in-line height
change condition.
1. Remove the lower top cap in the
intersection and trim the required
amount from its length. Replace
the trim.
Hint:
Use miter box to ensure a
straight cut.
Note:
The installation of height
change trim requires that the
adjacent lower top cap trim be
shortened by either 2” or 4”,
depending on the application
(Figure 64).
2. Snap the in-line height change
trim into place over the full post
(Figure 65).
Note:
Face the opening of all
height change connector blocks
toward the shortest panel to
allow for lay-in wire management
(Detail S).
Содержание WireWorks
Страница 1: ...Assembly Instructions WireWorks Panel System January 2020...
Страница 2: ...A...
Страница 46: ...44...
Страница 47: ...45...