18
WireWorks
®
Panel System
Assembly Instructions
Assemble units as described herein only. To do otherwise
may result in instability. All screws, nuts and bolts must be
tightened securely and must be checked periodically after
assembly. Failure to assemble properly, or to secure parts
may result in assembly failure and personal injury.
Installing in Base Raceway
WARNING:
Assembly of all
mechanical frame components
must be completed before
making any electrical
connections. All electrically
connected furnishings must also
be mechanically connected.
1. Determine the position at which
the receptacle will be installed
and ensure a rigid wireway is
already mounted behind the base
raceway door.
2. Carefully remove the steel
knockout by pressing on the
edges until it snaps out of the
square opening.
3. Close the raceway door and snap
a bezel into the opening from
the front of the base (note “this
end up” orientation of bezel).
If data connection is required,
snap a data faceplate (supplied
by the customer) into the lower
opening in the bezel. Refer to
Planning Guide
Data Cable
Management
to additional
information. If data faceplates
are not being used, snap the
included bezel filler plate into the
unused bottom opening of the
bezel from the inside (Figure 20).
Note:
The bezel filler plates
always occupy the lower of the
two openings on bezels in base
raceways. The bezel filler plate
can be snapped in place such
that it is flush with the bezel face
(Figure 20), or rotated to allow
data cables to exit (Detail F).
Installing Receptacles
WARNING:
Assembly of all
mechanical frame components
must be completed before
making any electrical
connections. All electrically
connected furnishings must also
be mechanically connected.
1. Position the receptacle on either
end of the wireway as shown
(depending on location desired),
matching the
N
symbol to the
same orientation on both the
receptacle and wireway.
2. Align the receptacle so the end is
in line with the inner socket on
the wireway (Figure 21).
3. Push the receptacle back against
the mounting plate (Figure 21).
4. Slide the receptacle to the side so
the end terminals slide into the
wireway inner socket (Figure 22).
5. Receptacle is properly seated
when the catch clip on the
wireway is between the wedges
on the receptacle (Figure 23).
Removing Receptacle
1. Slightly lift the catch clips on the
top and bottom of the receptacle
(Figure 23) and slide the
receptacle away from the socket
on the wireway.
2. Pull the receptacle away from
the wireway once the end of the
receptacle clears the wireway
socket.
Содержание WireWorks
Страница 1: ...Assembly Instructions WireWorks Panel System January 2020...
Страница 2: ...A...
Страница 46: ...44...
Страница 47: ...45...