42
WireWorks
®
Panel System
Assembly Instructions
Assemble units as described herein only. To do otherwise
may result in instability. All screws, nuts and bolts must be
tightened securely and must be checked periodically after
assembly. Failure to assemble properly, or to secure parts
may result in assembly failure and personal injury.
Stacking Vertical Posts
Stacking vertical posts come in
12”, 18”, and 24” heights for both
full and half posts. Using stacking
posts, you can add height to panels
already installed. Please note
that there are restrictions to how
stacking sections can be used with
load-bearing components. Refer
to the Planning Guide for more
information.
1. Install a stacking section by first
removing the top cap, any wires
from the top of the vertical post
and the top trough cable guard if
equipped.
2. Position the stacking splice above
the top of the vertical post and tap
into place. Do not damage top of
stacking splice during installation.
Continue adding stacking sections
as required (Figure 69).
Note:
When installing half post
stacking sections, be sure the
vertical slots in the stacking post
are aligned with the slots in the
post beneath it.
3. After the necessary stacking
sections are in place, add the
necessary horizontal rails, tile
hooks, tiles and trim to complete
the installation (Figure 70).
Adding Intersections
WireWorks panels are designed
with modular trim at the
intersections.
1. Add another panel to an
intersection by simply removing
the universal trim that is covering
the side to which you will be
adding another panel run
(Figure 71).
2. Bolt a new half post into the
connector block and continue to
install the additional panels as
described in the previous sections
(Figure 72).
Содержание WireWorks
Страница 1: ...Assembly Instructions WireWorks Panel System January 2020...
Страница 2: ...A...
Страница 46: ...44...
Страница 47: ...45...