- 1 -
Record Master
®
Installation Instructions
General Instructions
1. Check parts and bundles against packing slip to be sure all parts and bundles
were received.
2. Sort parts so that like parts are together. This will make installation easier and
faster.
3. Read through the entire instruction sheet carefully before attempting to
assemble Record Master units.
4. Determine that the floor will support shelving load. It is the end users' respon-
sibility to provide adequate flooring.
5. Check your floor plan for layout and assemble from left to right. Measure and
mark floor for intended layout; pre-plan exact location of all units with regard to
columns, lights, windows and obstructions.
6. All uprights must be level and plumb. Shim under bottom of posts. If not level
and plumb, it will be difficult to assemble adder units and component parts.
7. Units may be secured to walls with wall anchors and to each other using "U" or
clothespin clips. Ranges may be anchored across open aisle to opposite units
or to a wall with aisle ties.
8. If assembled units are to be moved about on a dolly or by hand truck, the
bottom shelf and supports must be locked in place by inserting four (4) safety
plugs in post keyhole above shelf surface.
Installation Steps
1. Uprights & Shelf Supports
a. Assemble units from bottom up.
b. Hold uprights in place and temporarily insert shelf
support near mid-point on back posts to space uprights.
c. Locate bottom shelf support with rivet tabs down at back
of unit.
••• For 2-1/2" front base, insert rivet shoulder in 1st and
2nd keyhole slots.
••• For 4-1/4" front base, insert rivet shoulder in 2nd
and 3rd keyhole slots.
2. Front Base
a. Place front base inside upright front posts and insert front
bottom shelf support with rivet tabs down, positioned as
noted in Step 1c.
b. Shelf support retains front base in place.
STEP 1
STEP 2
