Keysight Technologies N5171B EXG, Руководство пользователя

Страница: 68 / 473

52 Keysight EXG and MXG X-Series Signal Generators User’s Guide
Basic Operation
Configuring a Swept Output
13. As desired, repeat step 12 for the remaining points for which you want to select a waveform.
The following figure shows an example of how this might look.
14. Turn sweep on:
Press Return > Return > Return > Sweep > Freq Off On > Amptd Off On > Waveform Off On .
15. If it is not already on, turn the RF output on:
Press RF On/Off .
The
SWEEP
annunciator appears on the display, indicating that the signal generator is
sweeping, and the progress bar shows the progression of the sweep.
Example: Using a Single Sweep
1. Set up either a step sweep ( page 48 ) or a list sweep ( page 50 ).
2. In the List/Sweep menu, set the sweep repeat to single:
Press Sweep Repeat Single Cont to highlight Single.
Sweep does not occur until you trigger it.
Note that the
WINIT
annunciator appears on the display, indicating that the sweep is waiting
to be initiated.
3. If not already on, turn the RF output on: Press RF On/Off .
4. Initiate the sweep: Press Single Sweep .
A single repetition of the configured sweep is available at the RF Output connector.
As the signal generator sweeps, the
SWEEP
annunciator replaces
WINIT
on the display, and the
progress bar shows the progression of the sweep.
At the end of the sweep, there is no progress bar, and the
WINIT
annunciator replaces
SWEEP
.
If the instrument is in manual sweep ( page 53 ), the active row (row 6 in the
figure above) is the selected (manual) point, and the signal generator
outputs the settings for that selection when the RF output is on.
The empty entry is equivalent to
choosing CW (no modulation).