Keysight Technologies N5171B EXG, Руководство пользователя

Страница: 66 / 473

50 Keysight EXG and MXG X-Series Signal Generators User’s Guide
Basic Operation
Configuring a Swept Output
Example: Configuring a List Sweep Using Step Sweep Data
1. Set up the desired step sweep, but do not turn the sweep on. This example uses the step
sweep configured on page 48 .
2. In the SWEEP menu, change the sweep type to list:
Press SWEEP > Sweep Type List Step to highlight List.
The display shows sweep list parameters, as shown below.
3. Open the List Sweep menu: Press More > Configure List Sweep .
4. Clear any previously set values from the menu and load the points defined in the step sweep
into the list: Press More > Preset List > Preset with Step Sweep > Confirm Preset .
The display updates with the values loaded from the step sweep, as shown.
5. Sweep frequency and amplitude: Press SWEEP (hardkey) > Sweep > Freq Off On > Amptd Off
On .
Setting the sweep turns on the sweep function; a continuous sweep begins. On the display,
the
SWEEP
annunciator appears, and the progress bar shows the progression of the sweep.
6. If not already on, turn the RF output on: Press RF On/Off .
The RF Output LED lights, and a continuous sweep is available at the RF OUTPUT connector.
Example: Editing List Sweep Points
If you are not familiar with table editors, refer to page 42 .
1. Create the desired list sweep. This example uses the list sweep created in the previous
example.
Vector Models:
Presetting the list clears any
previously selected waveforms.
For information on selecting a list
sweep waveform, see “Example:
Editing List Sweep Points” on
page 50 .
Waveforms are available
only on vector models.