Series 2600B System SourceMeter® Instrument Reference Manual
Section 7: TSP command reference
2600BS-901-01 Rev. B / May 2013
7-119
Details
This attribute specifies the LAN subnet mask that will be used when the manual configuration method is used to
configure the LAN. This setting is ignored when DLLA or DHCP is used.
This attribute does not indicate the actual setting presently in effect. Use the
lan.status.subnetmask
attribute to determine the present operating state of the LAN.
Example
print(lan.config.subnetmask)
Outputs the LAN subnet mask, such as:
255.255.255.0
Also see
lan.restoredefaults()
(on page 7-121)
lan.status.subnetmask
(on page 7-127)
lan.linktimeout
This attribute contains the LAN link timeout period.
Type
TSP-Link accessible
Affected by
Where saved
Default value
Attribute (RW)
Yes
LAN restore defaults
Nonvolatile memory
20 (20 s)
Usage
timeout
= lan.linktimeout
lan.linktimeout =
timeout
timeout
The LAN link monitor time-out period (in seconds)
Details
You must enable the command
lan.autoconnect
before you can use this attribute.
The
timeout
value represents the amount of time that passes before the instrument disconnects from the LAN
due to the loss of the LAN link integrity.
The LAN interface does not disconnect if the connection to the LAN is reestablished before the
timeout
value
expires.
If the LAN link integrity is not restored before the
timeout
value expires, the instrument begins to monitor for a
new connection.
Example
print(lan.linktimeout)
Outputs the present LAN link timeout setting.
Also see
lan.autoconnect
(on page 7-112)
lan.restoredefaults()
(on page 7-121)
Содержание System SourceMeter 2601B
Страница 841: ......