Keithley System SourceMeter 2601B, Справочное руководство

Страница: 485 / 864

Series 2600B System SourceMeter® Instrument Reference Manual Section 7: TSP command reference
2600BS-901-01 Rev. B / May 2013 7-145
localnode.showerrors
This attribute sets whether or not the instrument automatically sends generated errors.
Type TSP-Link accessible Affected by Where saved Default value
Attribute (RW) Yes Power cycle Not saved 0 (disabled)
Usage
errorMode = localnode.showerrors
localnode.showerrors = errorMode
errorMode Enables (1) or disables (0) the show errors state
Details
If this attribute is set to
1
, the instrument automatically sends any generated errors stored in the error queue, and
then clears the queue. Errors are processed after executing a command message (just before issuing a prompt,
if prompts are enabled).
If this attribute is set to
0
, errors are left in the error queue and must be explicitly read or cleared.
When using this command from a remote node,
localnode
should be replaced with the node reference, for
example,
node[5].showerrors
.
Example
localnode.showerrors = 1 Enables sending of generated errors.
Also see
localnode.prompts (on page 7-141)
makegetter()
This function creates a function to get the value of an attribute.
Type TSP-Link accessible Affected by Where saved Default value
Function No
Usage
getter = makegetter( table , attributeName )
getter
The return value
table
Read-only table where the attribute is located
attributeName A string representing the name of the attribute