Jumil 3090PD, Инструкция по эксплуатации

Страница: 76 / 176

76
3090PD
Fig. 050
Fig. 051
A
4.9.2 - Changing the position of the shooting and ratchet
When exchanging spacings can occur there need to make the change the positioning of the tread That should
make the alignment occurring ratchet, as follows:
a) Loosen the nuts on the clamp bracket bearing ratchet;
b) For the turnstiles with footswitch, loosen the nuts clamp the guide disarm alavancade ratchet;
c) For the turnstiles with manual override, loosen the bolts securing the support of the release lever ratchet;
d) Slide the ratchet assembly to the point of alignment between the gears of the drive wheel and ratchet gear;
e) Attach the screws and / or clips again
f) Place the drive chain from x ratchet wheel driving then make the alignment of
currents;
g) Attach the stabilizer arm locking and unlocking of the ratchet
ATTENTION:
The turnstiles are factory regulated and aligned in relation to filming With exchange of position shooting,
make new adjustment and alignment between the tread and gears ratchet gear for perfect transmission
operation.
In planters equipped with four-wheel drive, the eventual disarming some ratcheting can occur due to
irregularities in the soil.
Perform analysis of the spring pressure of routinely ratchets The loss of spring pressure causes the
ratchet trip more often.
The screws that secure the retaining rings compression springs of the turnstiles, have the cilindircas
tips It was necessary to use the recommended replacement screw (Pf Sext MA10x25 Total Thread DIN 933-8.8),
because otherwise will not allow the opening and closing of the ratchet.
Avoid reverse gear maneuvers with the planting lines resting on the ground This may cause damage to
the turnstiles, double disks, compactors and profunidade controllers.
We recommend that you do not make reversing maneuvers in too long distances, mesmocom lines of
raised planter, to prevent damage to the transmission system and turnstiles.
The tread ratchet drive chain must be removed to transport the machine at distances greater than 3 km.
Failure to observe this orientation can lead to premature wear of the teeth of the tread drive ratchet.
4.10 - Turbines
4.10.1 - Turbine powered by hydraulic motor (optional)
Hydraulic Motor for tractors equipped with contralador for continuous oil flow to at least 27 liters per minute for
the turbines implements 08/10/12/13/15L, ande 54 liters per minute for the turbine implements 18L (Fig. 052).
4.10.2 - Hydraulic drive turbine
The use of hydraulic drive turbine system requires some basic guidelines, whereas JUMIL have the following
options that can be fitted on tractors of various makes and models.
4.9.1 - Regulating the stabilizer arm
The ratchet has an arm stabilizer which has the function of allowing the adjustment of the spring pressure of
the engagement between the fixed arm and the ratchet arm stabilizer To adjust move the locknut “A” and the regulatory
ratchet to desired pressure (Fig. 051).
When the planter is lowered, the turnstile should be closed but with the system of free hitch.
IMPLEMENT MOUNTING