Jumil 3090PD, Инструкция по эксплуатации

Страница: 100 / 176

100
3090PD
Item
Description of tasks
Frequency
10h or
daily
Weekly
Final
planting
Before
planting
13.4 • ratchet and drive system of the turnstiles
X X
13.5 • hatched and hatchet drive system
X X
14 Check the tension and alignment of chains:
X X
14.1 • wheels x turnstiles
X X
14.2 • ratchets x gear lever
X X
14.3 • gear lever x drive shafts of fertilizer and seeds
X X
15 Check the wear of the components of fertilizer spreaders
X
16 Check the thread pitch of the worm fertilizer spreaders
X
17
Check if there is damage to the hoses of fertilizer and seed con-
ductors
X X
18
Make cleaning the fertilizer spreaders
X X
19 Check wear of the components of the turnstiles
X X
20 Check wear of chains and gears
X
21 Check clearances of bearings
X
22 Check wear of the wipers of double discs
X
23 Check wear of the double discs
X
24 Make the cleaning of the conductors of fertilizer and seeds
X
25 Check cracks and points of welds
X
26 Check wear of bushings pantograph system of units seeds
X
27
Check that you have rusty parts
X
28 Check wear of the components of the distribution of seed box
X
29 Check for damage in the bands of depth controllers
X
30 Check for damage on the wheels of rice kit
X
31 Check for wear of the bearing components:
X
31.1 • the double discs
X
31.2 • of floating compactors
X
5.3 - Corrective maintenance
Corrective maintenance is necessary to effect repairs or replacement of components which may cause dama-
ge during operation and can compromise the use of the implement activity. The objective of the corrective maintenance
is to restore the system for satisfactory operation within the shortest possible time.
Corrective maintenance should be performed by trained personnel, observing the form of assembly of compo-
nents, use proper tools, and replace the broken parts with original parts. After the repair should observe the necessary
components for the functioning of settings.
We describe below some corrective maintenance guidelines:
ATTENTION:
Ensure the implement is properly footwear and property, before making any repairs.
When operating the hydraulic system to raise or lower the implement, in permits anyone
nearby.
5.3.1 - Tire change
In case you need to make any repairs to the implement tires, proceed as follows:
a) Place the implement at a local level;
b) Operate the hydraulic system, leaving the implement fully supported to the ground;
c) Lower the support legs until they are flat on the floor;
d) Use the rear strut tube to sustain the weight of the implement;
MAINTENANCE