Jumil 3090PD, Инструкция по эксплуатации

Страница: 75 / 176

75
3090PD
Excess pressure Lack of pressure Correct pressure
ATTENTION:
Perform tire fitting with suitable equipment The service must be performed only by persons
trained for the job.
Never weld a wheel with tire mounted, heat can cause an increase in air pressure and cause
the tire to explode
The filling position the tire side of the tire, not in front of it.
The wheels that present any types of cracks should not be repaired, nor reused.
Fig. 049
4.8.5 - Slipping sprocket
The slipping of the driving wheel planter is undesirable when it comes to precision the amount of seed per
hectare. Many factors may cause slipping, including soil condition, the weight of the planter and the tire pressure.
4.8.6 - Care for the system of wheels and tires
The shooting system is responsible for much of the performance of the planter, to ensure long life of the tires,
the following care should be taken:
a) The tires must this with the correct pressure, lack or excess pressure causes premature tire wear and affect
the accuracy in the distribution of seed and fertilizer;
b) Do not overload the planter to avoid wheel deformation and consequent damage to tires;
c) The wheels that provide all types of cracks should be repaired or reused under major accident hazards;
d) Perform routine check if the wheel bolts are properly tightened.
IMPORTANT:
No warranty is granted to the tires that are experiencing damage from “picotamento” of crop residues,
or “rubbing” side caused by contact of the components of the planter when exchanging spacings.
ATTENTION:
Check daily the need to make the tightening of nuts on wheel bolts Remembering that there are screws
with right and left thread.
The conditions of crop residues are important agents in the life of the tire, so avoid leaving stumps with
height that can become resistant and cause “picotamento” tires during planting.
4.9 - Ratchets Drive
The turnstiles automatically activate and deactivate the flow of fertilizer and seeds Are provided in the model -
standard drive (Fig. 050), positioned in the planter and manual drive platform - optional (Fig. 050) positioned in front of
the planter When actuated to allow seeding of only one side of the planter, or half lines, facilitating the trim To make the
drive ratchet to trim, do the following:
a) Choose the side of the planter to be made the tailpiece;
b) When manually activated, pull the lever until it snaps into second top, thus unlocking the ratchet and disa-
bling side that will not be sown;
c) After the tailpiece activate again until the lever snaps in the first top.
IMPLEMENT MOUNTING