Jumil 3090PD, Инструкция по эксплуатации

Страница: 69 / 176

69
3090PD
Fig. 037
A
A
A
CAUTION:
The marker lines leaves the factory with the locking pin “A” (Fig. 037), used for transportation, and
the disc-facing side of the planter. Before making the drive of the hydraulic system and make assembly and
adjustments for marking lines, remove the retaining pin and attach to the chassis of the machine and mount
the disk in working position.
4.5.1 - Procedure for mounting the marker lines
The planters Fertiliser
3090PD
shipped with markers mounted line, however, pos cut discs are mounted facing
the side of the planter, in order to avoid risks of accidents in transporting the planter.
ATTENTION:
Use the fixing pin “A” (Fig. 037) every time we make transport for the planter, is carried by the tractor
or truck or trailer transport.
There are three types of line markers, one for each type of planter (Fig. 038), but to assemble the marker disc
on the right or left marker lines, note should be taken that only the set of the marker disc and mounted in the working
position, as instructed below:
a) Loosen the fixing clamps “A” holding supplementation marker rod to set the marker, then remove the entire
label of the supplement (Fig. 039);
b) Place the sets of markers to the ground noting that it stay with the wipers of the discs facing the cleaning
position (Fig. 040);
c) For the operation of work, make the adjustment of the angle of attack of the disc cut through the toothed nut
“B”. After the adjustment of the set screw nuts (Fig. 041).
IMPLEMENT MOUNTING