Selenio
TM
BNP User Guide, Release 3.7.1
132
- Grooming - Mapping
2.
View results of the program configuration at the
Outputs
panel of the
Mapping
page, directly
beneath the selected TS.
For information about the
Messaging System Setting
button, see “Program Messaging System
Table 68.
Create Output Program Configuration Parameters
Field
Description
Port Parameters
Port ID
Read-only field. The GigE or ASI port on which the program resides.
IP Address
Read-only field. The destination IP address of the transport stream.
UDP Port
Read-only field. UDP port the program uses, based on UDP port of the transport
stream.
TS Parameters
TS ID
Read-only field. The ID number of the transport stream on which this program
streams.
TS Type
Read-only field. Indicates the type of transport stream for the program.
Program/Channel Info Parameters
Program Number
MPEG number assigned to this program
Program Name
Name assigned to this program. Output program names must be unique.
PMT PID
Select this option to activate the PMT ID box, into which you can then enter the PMT
ID, or the ID of the program map table (PMT).
To set a PMT PID, enter a decimal value in this field.
Note that display of this entry, in applicable screens, is dependent on the current
setting—as either hexadecimal or decimal—for
Configuration
-->
Global PID
Display.
Major Channel
Number
Operator-defined channel number: for terrestrial broadcast, the major channel
number is limited to the range 1 to 99 for ATSC digital television or audio services. For
cable, major channel numbers may range from 1 to 999.
This field can be edited if ATSC is enabled.
Minor Channel
Number
Operator-defined minor channel number: any whole number in the range from 0 to
999.
This field can be edited if ATSC is enabled.
Enable DPI
a
Select this option to enable DPI for the program only, rather than the whole TS.
• This option is hidden unless a PROGRAM WITH DPI license key has been entered
in the License Manager screen (see also “Managing Licenses” on page 190.
Allow SCTE 30- to-
SCTE 35 conversion
When checked, enables SCTE 30 to SCTE 35 conversion.
Allow Audio
Mismatch During DPI
Check this box to allow ads to have a different audio format from the input program
during DPI. By default, ads must have the same audio format as the input program.
Note: Audio mismatch is limited to MPEG-1 and MPEG-2 audio types.
Note: If you enable this feature while DPI is active on the output program, then the
audio mismatch is allowed only from the next set of ads.
Note: PMT is not updated even if the BNP matches MPEG-1 audio to MPEG-2 audio.
ETV Configuration
b
Parameters
