IBM totalstorage 326, Справочник пользователя

Страница: 176 / 240

The state of the GBIC mode is saved in flash and stays activated
(even after restarts or power on and off cycles) until it is disabled as
follows:
sw:admin> setGbicMode 0
An example mode of operation is to disable the hub, set the GBIC
mode to 1, and execute the spinSilk command which would limit its
testing to:
v
All ports with GBIC and embedded optics present.
v
All ports with GBIC and embedded optics present properly
cable-loopbacked
Note: When running the spinSilk test, you must set the operating
mode value to 0 or 1. Modes 2 and 3 do not send out the
ELP used to discover switches and hubs. If the ELP is not
sent, the hub does not know the port is connected to another
port on the same hub and the test fails. Using operating
mode 0 when running spinSilk is preferred.
If you do not include the nMillions parameter (the number of frames
for the test to execute, in millions of frames), the spinSilk test runs
until you press
Enter .
sramRetentionTest
Verifies that:
v
Data written into the ASIC memories are retained
v
Data bits do not drop when read after some amount of delay
since the write
supportShow Prints the hub information for debugging purposes. The
supportShow command executes the following commands in the
order shown:
v
version
v
tempShow
v
psShow
v
licenseShow
v
diagShow
v
errDump
v
switchShow
v
portFlagsShow
v
portErrShow
v
mqShow
v
portSemShow
v
portShow
v
portRegShow
v
portRouteShow
v
fabricShow
v
topologyShow
v
qlShow
v
nsShow
v
nsAllShow
v
cfgShow
v
configShow
v
faultShow
v
traceShow
v
portLogDump
164
Model 326 User’s Reference